重戰機 Heavy Metal Ashura Temple 進度八

小腿打開果塊要補返長, 但係之後唔可以就咁攝返入褲腳, 所以褲腳都要分件, 加可動, 如圖右邊, 腳檔側落少少, 就夠位打開塊甲


分左件, 順便加長2mm, 另預留2mm攝入褲腳, 共加4mm
界開之後發現原形左右腳有D位都唔對稱, 長短邊, 兩邊要加既膠板厚度都要調整


腳檔設定中, 似係圓中帶方, 好難理解


所以分幾晚整, 整左方既部份, 硬後再整圓位, 稍後磨薄D、圓D、對稱D


上網睇舊post原來Robot魂Side HM係1/144, 聽日出去買隻C temple返來玩
搵參考, 學晒人地D好野, 唔好果D唔學
呢個都有改薄隻手, 膊頭都有升高2,3mm。我會將頭頂倉改成方形
http://www.fg-site.net/archives/post_old/67007

呢個我鐘意佢下身, 褲腳果度我想學, 但係唔知佢做左D乜, 點樣將原本唔凸既褲腳cut成凸, 所以我最後用AB putty
但上身 膊頭太過份, 小腿打開, 但係開錯左右腳
http://www.fg-site.net/archives/post_old/127454

呢個就鐘意佢上身, 膊頭都係升2,3mm, 唔過份, 腰換成A-taul, 長度適當.
整體橫向, 但係小腿又係開錯左右
http://www.fg-site.net/en/archives/post_old/50602

硬係冇改好既A Temple成品, 唔通我都係.....
長腰都冇好
http://www.fg-site.net/archives/post_old/36054
http://www.fg-site.net/en/archives/2676896
http://www.fg-site.net/archives/post_old/151517